Descripción
Shure SBM910
Shure SBM910 CHARGING MODULE
The SBM910 Battery Charging Module from Shure is for the Axient Digital wireless system. The module can be used to charge the SB910 batteries.
Charging modules for handheld and body-worn devices can be installed interchangeably in the charger.
Caution! When installing charge modules, disconnect power and remove batteries.
- To remove a module, remove the four (4) mounting screws and pull out.
- To install, slide the module into the box (noting the orientation of the guide rails) until it is flush with the box.
- Replace the screws.
- Battery packs can explode or release toxic materials. Risk of fire or burns. Do not open, crush, modify, disassemble, heat above 140 ° F (60 ° C), or incinerate.
- Follow the manufacturer’s instructions
- Use only the Shure charger to charge Shure rechargeable batteries.
- WARNING: If the battery is incorrectly replaced, there is a risk of causing an explosion. Replace only with the same or equivalent type.
- Never put batteries in your mouth. If swallowed, see a doctor or a local poison control center.
- Do not short circuit; this can cause burns or fires
- Do not charge or use batteries other than Shure rechargeable batteries.
- Dispose of battery packs properly. Consult local dealer for proper disposal of used battery packs.
- Batteries (battery packs or installed batteries) should not be exposed to excessive heat caused by sunlight, flames, or similar conditions.
- For SB910 Batteries
- Fits Axient Digital Wireless Systems
- Compact Design
